The libusb package contains a library used by some applications for. If Doxygen is installed and you wish to build the API documentation,.
Links for libusb-1.0-0
Debian Resources:
Download Source Package libusb-1.0:
Maintainer:
Aurelien Jarno (QA Page)
External Resources:
Homepage [www.linux-usb.org]
Similar packages:
userspace USB programming library
Library for programming USB applications without the knowledgeof Linux kernel internals.
This package contains what you need to run programs that use thislibrary.
Other Packages Related to libusb-1.0-0
depends
recommends
suggests
enhances
dep:multiarch-support
Transitional package to ensure multiarch compatibility
dep:libc6 (>= 2.17)
GNU C Library: Shared libraries also a virtual package provided by libc6-udeb
dep:libudev1 (>= 183)
libudev shared library
Download libusb-1.0-0
Download for all available architectures
Architecture
Package Size
Installed Size
Files
amd64
47.0 kB
111.0 kB
[list of files]
armel
41.4 kB
125.0 kB
[list of files]
armhf
41.6 kB
109.0 kB
[list of files]
i386
49.8 kB
145.0 kB
[list of files]
The Digispark is an Attiny85 based microcontroller development board similar to the Arduino line, only cheaper, smaller, and a bit less powerful. With a whole host of shields to extend its functionality and the ability to use the familiar Arduino IDE the Digispark is a great way to jump into electronics, or perfect for when an Arduino is too big or too much.
This package provides the Gobot adaptor for the Digispark ATTiny-based USB development board with the Little Wire protocol firmware installed.
How to Install
This package requires libusb.
OSX
To install libusb on OSX using Homebrew:
Ubuntu
To install libusb on linux:
Now you can install the package with
How to Use
How to Connect
If your Digispark already has the Little Wire protocol firmware installed, you can connect right away with Gobot.
Otherwise, you must first flash your Digispark with the Little Wire firmware.
The easiest way to flash your Digispark is to use Gort https://gort.io.
Download and install Gort, and then use the following commands:
Then, install the needed Digispark firmware.
OSX
Important: 2012 MBP The USB ports on the 2012 MBPs (Retina and non) cause issues due to their USB3 controllers,currently the best work around is to use a cheap USB hub (non USB3).
Plug the Digispark into your computer via the USB port and run:
Ubuntu
Ubuntu requires an extra one-time step to set up the Digispark for communication with Gobot. Run the following command:
You might need to enter your administrative password. This steps adds a udev rule to allow access to the Digispark device.
Once this is done, you can upload Little Wire to your Digispark:
Windows
We need instructions here, because it supposedly works.
Manual instructions
For manual instructions on how to install Little Wire on a Digispark check out http://digistump.com/board/index.php/topic,160.0.html
Thanks to @bluebie for these instructions! (https://github.com/Bluebie/micronucleus-t85/wiki/Ubuntu-Linux)
Now plug the Digispark into your computer via the USB port.